Advertenties
Beschikbare talen
Beschikbare talen
All manuals and user guides at all-guides.com
7. Commissioning
First take the outdoor sensor into operation and then the weather station.
a) Outdoor Sensor
• Open the battery compartment of the outdoor sensor. For this, remove the wall holder and
then remove the battery compartment lid by turning out the 4 attachment screws.
• Select the transmission channel of the outdoor sensor by setting the slider in the
battery compartment of the outdoor sensor accordingly.
When operating only a single outdoor sensor, always set the channel to 1. If
several outdoor sensors are operated (up to 3 are possible), set a different
channel for each outdoor sensor.
• Insert two type AAA/Micro batteries in the battery compartment in the correct polarity
(observe plus/+ and minus/-).
The display of the outdoor sensor briefly shows all display segments, and then the first
measured value for temperature and humidity. The set channel number („CH1", „CH2"
or „CH3") is displayed at the upper edge of the display.
• Briefly push the button „°C/°F" in the battery compartment of the outdoor sensor to
switch between the temperature unit °C (degrees Celsius) and °F (degrees Fahren-
heit).
• Close the battery compartment of the outdoor sensor again.
The LED below the LC display flashes briefly (approx. every 60 seconds) when the
outdoor sensor sends the measured values. The display of the outdoor sensor briefly
shows a radio tower symbol at the upper left.
b) Weather Station
• Open the battery compartment on the back of the basis station.
• Insert two type AAA/Micro batteries in the battery compartment in the correct polarity
(observe plus/+ and minus/-).
• Close the battery compartment again.
• Right after inserting the batteries into the weather station, all display segments appear
briefly and a beep is emitted.
30
Advertenties
