Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
18.6 Electrical connection
To protect the device, only remove the device from the
styrofoam shells when you press the device into the
cut-out. Never place the device upright on one side of
the device.
¡ Check the household wiring before connecting the
appliance.
¡ The appliance fulfils the requirements of protection
class I and must only be operated in conjunction
with an earth conductor.
¡ In the permanent electrical installation, a partition
must be provided in the phases in accordance with
the installation regulations.
¡ If
appears on the appliance's display, it has
not been connected correctly. Disconnect the appli-
ance from the mains and check the connection.
Connecting without a pre-installed cable
Only connect the hob in accordance with the connec-
tion diagram.
¡ If required, install the enclosed copper bridges.
¡ For a 3-/2-phase connection (3 N~/2 N~), the
power cable must correspond to type H05 VV-F or a
higher rating.
¡ Use the current load to determine which wire cross-
section you require. A cross-section of < 1.5 mm² is
not permitted.
¡ For a single-phase connection (1 N~), the power
cable H05RR-F3G4 (length 1 m) is available from
customer service.
18.7 Installing the hob
Do not trap the power cable and do not route it over
sharp edges.
¡ If the oven is a built-under type, route the cable
along the rear corners of the oven to the mains
socket.
¡ Push the hob in until it locks into place.
18.8 Removing the hob
Disconnect the appliance from the power supply.
1.
Push out the hob from below.
2.
46
Advertenties
Hoofdstukken
Inhoudsopgave
