Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Whitehaven Fan Installation Instructions
The LED light has a 3-step dimmable function which is controlled by remote light button " ON/OFF" .
When the LED light is ON and at 100% brightness, press the light button "ON and then OFF within 5 seconds", to dim
the LED light. Repeat pressing ON and then OFF within 5 seconds to dim further in the following sequence: 100%
brightness → 40% brightness → 15% brightness → 100% brightness.
To switch back to 100% brightness at any stage, turn OFF the luminaire, and then wait after 5 seconds turn ON the
luminaire, it will reset to 100% brightness.
THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTION:
⚫
Lock position: the receiver has a built in safety feature to protect against obstruction during operation. The motor
will be locked from operation and will disconnect from power after 30 seconds of interruption. Please remove
obstacles before re-starting. To reset, simply turn off the power supply to the fan motor and re-start.
⚫
Over 80W protection: when the receiver detects power consumption which is greater than 80W, the receiver power
will be stopped and operation will immediately discontinue. Turn the receiver power on after 5 seconds to restart the
fan.
REPAIRING THE FAN RECEIVER & REMOTE PAIRING
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the
receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC ceiling
fan remote and receiver.
Issues:
⚫
Loss of control - Fan is only running at high speed after installation
⚫
Loss of control - No reverse function after installation
⚫
Loss of control - Remote cannot communicate with receiver
Solution:
Switch OFF the main power to ceiling fan for 30 seconds.
A.
Press and hold the "
B.
the receiver of the ceiling fan.
Turn ON and change the speed of the ceiling fan via the transmitter to check the operation and successful paring.
C.
WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the fan
was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite acceptable
and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod are secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction
on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling fan become un-
balanced again. Store your balancing kit away after installation for future use if required.
10 | P a g e
" button on transmitter for 3－5 seconds within 60 seconds of switching the power ON to
AFTER INSTALLATION
Advertenties
Inhoudsopgave
