Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The buttons on the control panel have to be held down to move the desktop.
5. Settings
5.1 Configuring memory positions
Press the "Up" or "Down" button until the desired height is reached.
=
The display indicates the desk height (e.g. 73 cm).
Press the "SAVE" button.
Press the desired "Memory position" button (e.g. button "2").
=
The display indicates S 2.
The display indicates the desk height after roughly 2 seconds.
5.2 Calling up memory positions
Press and hold the corresponding memory position button (e.g. button "1" or button "2", etc.).
=
The desktop is moved until the stored desktop height is reached. The desktop movement is stopped
whenever the button is released before the memory position has been reached.
5.3 Resetting to factory settings
This function can be used to reset the system to the factory settings.
Press and hold the buttons shown below for 3 sec.:
1
Press buttons "1" and "2" and the
2
"Up" button
=
The letter S and a number (e.g. S 4) are shown on the display.
Press the "Down" button until S 0 is shown on the display.
=
The display indicates S 0
Press the "SAVE" button.
=
The system has now been reset to the factory settings.
6. Maintenance work
■
Only use suitable tools for all activities and be sure to contact our customer service
department to clarify how to proceed.
■
A damaged mains cable must be replaced by the manufacturer, the manufacturer's
customer service staff, or similarly qualified personnel to prevent hazards.
6.1 Functional check
The components of the Solo Sit-to-Stand Desk must be checked for correct functioning at regular intervals.
Pay particular attention to the electrical connections:
The electrical equipment for the desk must be checked at regular intervals. Fix loose connections or damaged
cables immediately. Ensure you disconnect the desk from the electrical power supply beforehand.
Solo Sit-to-Stand Desk
7
Advertenties
Inhoudsopgave
