Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MOUNTING ON A VERTICAL WALL
Caution: To prevent this unit falling into water, do not install it above or
alongside your pond.
The unit may be mounted horizontally onto a vertical wall using the mounting
brackets included (see diagram below). The 8 screws provided are suitable for
fixing the brackets to a wooden surface. You should ensure that the unit is the
correct way round with the wall spacers positioned at the back of the unit.
Please note that there is no correct flow direction through the unit. Either end
of the unit may be used as the inlet or outlet. Hosetails should be tightened
using hand pressure only. Ensure that the "O" rings are in position before
assembling. Do not use jointing compound or PTFE tape.
CONNECTION TO THE WATER SUPPLY
Connection with flexible hose
The Pro Clear Ultima unit is supplied with two universal 45 o hosetails to take
38mm and 40mm diameter flexible hose. If you are using the larger size, the
smaller section of the hosetail must be cut off to ensure sufficient water flow
and prevent possible damage to the pump. We recommend that you use the
largest diameter hose available. The hosetails should be trimmed away from
the unit as shown in the diagram below. Using a hacksaw, carefully cut off the
excess hosetail, ensuring that the sections are cut off at the ridge and that the
cut follows the line of the ridge.
Once the hosetails have been trimmed, attach them to the unit as described
above. Secure the hosepipe to the hosetail with a stainless steel hose clip.
Connection using rigid pipe
This unit may also be rigid plumbed. Rigid 32mm pipe (not supplied) can be
attached directly to the inside of the hosetails using a suitable solvent cement.
To connect either 1.5" or 2" rigid pipe, first fit a 2" BSP plain to female
threaded union (TMC code: 7507 - please ask your local stockist) to the inlet
and outlet of the unit. To achieve a water tight seal you will need to use silicon
aquarium sealant on the threads and follow the manufacturer's instructions on
curing the silicon sealant
FLOW RATES
Unit
Pro Clear Ultima 30
Pro Clear Ultima 55
Please note that for optimum performance we recommend that you pass the
entire volume of your pond through the UV unit approximately once every
two hours. Please also note that we recommend a minimum flow rate
equivalent to passing the entire pond volume through the unit once every
three hours.
SYSTEM PRESSURE
This unit has been designed for use with all types of pond pump (working
pressure not to exceed 0.7 bar). Advice should be sought from your dealer if
the unit is to be subjected to abnormal conditions.
IMPORTANT: To ensure you understand how to safely install your unit,
please read the separate installation guidelines sheet enclosed with these
instructions.
+ +
+ +
+ +
+ +
1
Maximum Flow Rate
3,000 UK gallons/13,500 litres per hour.
4,000 UK gallons/18,000 litres per hour.
1. Mark the wall through the
2
2. Vertical wooden wall or
CUT LINE
2
brackets then fix with (8) 1"
No.8 screws
fence
Advertenties
Inhoudsopgave
