Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Instructions for
Installation and Use
This Pro Clear Ultima unit is supplied with two 45
connecting the clarifier to your water supply, two brackets for mounting the
unit and electrical connections which are similar to those found in a domestic
plug. Installation is explained below, but please read the following safety
information first.
- Consult a qualified electrician.
- Never look directly at an illuminated UV lamp.
- Do not run this unit dry. Do not cover this unit.
- Always isolate the unit from mains electricity and turn off the water supply
before carrying out any maintenance.
- Always disconnect all pond appliances from the mains supply
before putting your hands into the water.
- Use in the area of the garden pond only if the installation complies with the
relevant wiring regulations.
- Power must be supplied through a Residual Current Device (RCD) with
a rated residual operating current not exceeding 30mA.
- This unit must be earthed. Never use a fuse larger than 3 amps.
- Rating: 230V, 50Hz. 38-67 watt. Class 1. IP44.
- The unit must not be submerged in water.
- If the quartz sleeve is cracked, replace it immediately.
- The unit must be either fully frost protected or taken inside
during the winter months.
- Young children should always be supervised near water.
- This unit is CE approved.
- This unit is designed and manufactured in accordance with the following
directives:-
- the Low Voltage Directive 2006/95/EC.
- the Electromagnetic Compatibility Directive 2004/108/EC
to comply with the following standards:-
- BS EN 60335-1:2002+A15:2011 Safety of household and similar
electrical appliances. General requirements.
- BS EN 60335-2-55:2003+A1:2008 Particular requirements for
electrical appliances for use with aquariums and garden ponds.
- BS EN 61000-3-2:2006+A2:2009 Limits for harmonic current emissions.
- BS EN 61000-3-3:2008 Limitation of voltage changes, fluctuation or
flicker in low voltage supply systems.
Positioning the Pro Clear Ultima
Pro Clear Ultima units are weatherproof but not waterproof. The unit can
be positioned either on its base on a raised surface, or attached horizontally to
a vertical surface using the brackets provided. It must not be submerged in
water or placed in a position where water may collect around the unit.
If installing the unit prior to or without a filter, it is important that a pre-filter is used
on the water pump to prevent excess solids from being pumped into the unit. The
unit may be connected to the water supply using one of the options below:-
1. Pump with strainer
MOUNTING ON A HORIZONTAL SURFACE
Caution: To prevent this unit falling into water, do not install it above or
alongside your pond. Do not make the electrical connection to your unit until
it has been plumbed in and fixed securely.
If the unit is to be mounted on a flat surface, the final positioning of the
hosetails will dictate how to achieve this. It may be necessary to raise the unit
to avoid interference between the hosetails and the flat surface, which is best
achieved by using bricks or blocks firmly positioned under the feet of the unit.
Important Safety Information
- Please Read Carefully
Product Information
1
2
4
2. Filter
5
2
3. Pump
4. Gravity feed
o
universal hosetails for
1
3
5. Pressurised filter
DANGER
5
Advertenties
Inhoudsopgave
