Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Replacing the lamp
1.
Disconnect the appliance.
2.
Push the movable part to unhook the lamp cover
(1).
3.
Remove the lamp cover (2).
4.
Replace the lamp with one of the same power and
specifically designed for domestic appliances only.
5.
Install the lamp cover.
6.
Connect the appliance.
7.
Open the door. Make sure that the lamp comes
on.
Technical data
Dimension of the recess
Voltage
Frequency
The technical information are situated in the rating plate
on the internal left side of the appliance and in the ener-
gy label.
Installation
Caution! Read the "Safety Information" carefully
for your safety and correct operation of the
appliance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated
indoor (garage or cellar) also, but for optimum perform-
ance install this appliance at a location where the ambi-
ent temperature corresponds to the climate class indi-
cated on the rating plate of the appliance:
16
1
Closing the door
1.
2.
3.
Height
Width
Depth
Climate
class
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the rating plate correspond to your
domestic power supply.
2
Clean the door gaskets.
If necessary, adjust the door. Refer to "Installa-
tion".
If necessary, replace the defective door gaskets.
Contact the Service Center.
880 mm
560 mm
550 mm
230 V
50 Hz
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Advertenties
Hoofdstukken
Inhoudsopgave
