light on. The last setting is displayed on the LED screen and the light operates ac-
cording to the last setting.
5. To disconnect the power supply, move the on/off voltage selector switch (13) to the
'0' (off) position.
6. To disconnect the device from the mains voltage, first pull the Euro mains plug (26)
out of the power outlet and then remove the 2-pin power plug from the light.
FUNCTIONS & OPERATION
A wide range of functions can be set for this LED light using the two setting modes
"CCT" and "HSI".
1. If necessary, briefly press the [MODE] button (9) several times to switch between CCT
mode and HSI mode.
2. In CCT mode, the color temperature (in K) and the intensity value (in %) are dis-
played. These and other settings can be made here (see below).
3. In HSI mode, the RGB hue (<HUE>, in degrees), the saturation (<SAT>, in %) and
the intensity (in %) are displayed. These and other settings can be made here (see
below).
LIGHT SETTINGS
1. Briefly press the [MODE] button (9) to switch to CCT mode.
2. Turn the left adjustment knob (11) to set a color temperature between 2700K and
9999K.
3. Turn the right adjustment knob (19) to set the brightness between 0% and 100%.
RGB COLOR SETTINGS
1. Briefly press the [MODE] button (9) to switch to HSI mode.
2. Turn the left adjustment knob (11) to set the desired RGB color tone (<HUE>) be-
tween 0° and 360°.
3. Turn the right adjustment knob (19) to set the color intensity between 0% and 100%.
4. Press the left adjustment knob (11) to switch to the color saturation setting.
5. Turn the left adjustmement knob (11) to set the desired color saturation.
SPECIAL EFFECTS SETTINGS
Special effects part 1 (F1-12)
1. In CCT mode, press the [MODE] button (9) for about 3 seconds to switch to the mode
for special effects F1-12.
2. Turn the left adjustment knob (11) to set one of 12 special effects (left display value).
3. Turn the right adjustment knob (19) to set the brightness for the selected special
effect between 0% and 100%.
4. Briefly press the left adjustment knob (11) to access the intensity settings.
5. Turn the left adjustment knob (11) to set the intensity of the selected effect between
1 and 9.
Special effects part 2 (F1-F8)
1. In HSI mode, press the [MODE] button (9) for about 3 seconds to switch to the mode
for special effects F1-F8.
2. Turn the left adjustment knob (11) to set one of 8 special effects (left display value).
3. Turn the right adjustment knob (19) to set the brightness for the selected special
effect between 0% and 100%.
4. Briefly press the left adjustment knob (11) to access the intensity settings.
8