Start-up
To integrate the pluggable switch and meter into your
system and enable it to communicate with other Home-
matic IP devices, you must add the device to your Home-
matic IP Access Point first.
To add the pluggable switch and meter, please proceed
as follows:
•
Open the Homematic IP app on your smart-
phone.
Select the menu item "Add device".
•
•
Plug in the pluggable switch and meter into the
desired socket (see figure 2).
•
Pairing mode remains activated for 3 minutes.
You can manually start the pairing mode for an-
other 3 minutes by pressing the system button (A)
shortly (see figure 3).
•
Your device will automatically appear in the
Homematic IP app.
•
To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
•
Please wait until add is completed.
•
If add was successful, the LED lights up green.
The device is now ready for use.
•
If the LED lights up red, please try again.
34
•
Select the desired solution for your device.
•
In the app, give the device a name and allocate
it to a room.
After pairing, connected loads can be easily switched on
and off or the energy consumption can be measured.
6
Operation
After pairing and installing have been performed, simple
operations are available directly on the device.
•
Press the system button (A) shortly to switch on
and off connected loads.
Improper usage or a defective installation (e.g.
low-quality or defective plugs or sockets) can
lead to overheating of the pluggable switch and
meter. The integrated temperature control auto-
matically switches off the load. The devices is
protected against overheating and secure opera-
tion is ensured. As soon as the temperature
reaches a non-critical value, you can switch on
the pluggable switch and meter again. Always
observe the permitted ambient temperature of
the device and, if necessary, have the installation
checked for possible error sources by an expert.
Operation
35