Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5.4.1 Halogen lights | Replacing
the halogen bulbs [square]
Before replacing the lights, you must
disconnect the appliance by taking the
plug out of the socket or by switching off
the main switch.
Push the glass window at the „push"sign.
Make sure to open the window
completely.
Remove the defective light bulb.
Cut open the packaging of the new light
from the rear side. Attention: use halogen
light bulbs with the same wattage. Place
the new light from the packaging into the
fitting.
Never touch the glass of the bulb with your
fingers!
Push to close the glass window, until you
hear a click.
All manuals and user guides at all-guides.com
5.5 Maintenance of stainless steel
In the every day use, stainless steel
surfaces are being damaged and polluted.
These pollutions or damages can diminish
the resistance against corrosion or even
cause corrosion, depending on the nature
of the pollution. Pollution and damages are
not only bad to the corrosion sustainability
of the material, it will also have an effect
on the appearance of the material. Greasy
fingers, light deposits, scratches etc,
cause an neglected appearance.
Therefore, it is necessary that the
stainless steel is given regular
maintenance.
The stainless steel requires specific ways
of maintenance and is based on the three
different finishes, i.e. brushed, orbital
grinded and glass bead blasted.
In case of a strong pollution and damages
a change of the surface structure can exist
by cleaning. We therefore recommend to
only have a specialist taken care of these
kind of problems. Light pollutions (greasy
fingers, light deposits etc.) can be
removed as follows:
EN 13 Maintenance
Advertenties
Hoofdstukken
Inhoudsopgave
