Advertenties
Beschikbare talen
Beschikbare talen
•
Note: Any water droplets or condensation inside the water tank are a result of quality testing prior to
shipping.
IMPORTANT INFORMATION
•
For best performance, we recommend using distilled, purified or filtered water in your steamer. Tap
water contains minerals that can build up inside your steamer over time and reduce its efficiency or
even cause damage.
•
Never use perfumes, oils or other additives.
•
Always check the garment's care label before steaming, and always test fabrics for colourfastness in
an inconspicuous area. Steamers are not recommended for use on leather, suede, vinyl, plastic, or
other materials that are sensitive to steam.
•
During use the steamer and accessories will become HOT. Never try to fit or remove attachments
while still hot.
•
After preheating, prime the water pump by holding the steam trigger until steam forms.
•
It is normal to feel or hear the water pump inside the device. It may become louder when the water
level in the tank is low. Check and refill the tank when required.
•
Small amounts of dripping might occur during use. If excessive, your steamer needs time to get back
up to full temperature. Just allow the steamer a minute to reheat.
•
Wearing clothes immediately after ironing or steaming can actually create wrinkles. Always allow the
clothing to cool for about 5 minutes before wearing.
ATTACHMENTS
Fabric attachment
Use on garments labelled j that allow the use of steam. Tip: For items with printing/embellishment,
turn the garment inside out to avoid damage to sensitive areas.
Fitting/Removing (Fig. A)
1.
Make sure that the steamer and attachment are cool.
Hook the top of the attachment over the top edge of the steamer. Click the bottom edge into
2.
place. Make sure it is fully fitted and not loose or it may detach itself during use.
3.
Remove the attachment using the tab. When removing the attachment, watch out for condensation
that may have built up during use.
FILLING
1.
Place the steamer on its base on a stable surface.
2.
Open the cover (Fig. B).
3.
Pour slowly, to allow the air in the reservoir to escape, and avoid an airlock.
4.
Don't fill past the max mark on the reservoir, or water will escape in use.
5.
Wipe up any spillage.
•
To refill at any time during use, turn the steamer off by pressing the power button until the blue
indicator light goes out, unplug from outlet, and follow the above procedure.
•
After refilling, allow to reheat for 45 seconds and then prime the pump by holding the steam trigger
until steam forms.
4
Advertenties
