Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
10.
Service
WATER RELATED PROBLEMS
Symptoms Experienced
•
The faucet is leaking/dripping
water.
•
The faucet is dispensing wa-
ter on its own (ghost water)
•
The water stream is very
weak.
SOAP/DISINFECTANT/LOTION RELATED PROBLEMS
Symptoms Experienced
•
Only a small amount of
soap / disinfectant / lotion is
dispensed.
•
Too much soap / disinfectant
/ lotion is dispensed.
Possible Problem or Cause
If newly installed, the mains water
supply was not flushed thorough-
ly enough before installation,
resulting to dirt particles entering
the system causing problems with
components inside the system.
The sensor in the sector is dirty.
Issue with sensors in faucet head.
Possible environmental factors
such as bright light or super reflec-
tive surfaces affecting the sensors.
The mains water supply is not
completely set to open.
The shut off valve (if available) is
not completely set to open.
Possible Problem or Cause
The pre-selected amount of dis-
pensed liquid is to high/low.
33
Solution
Disconnect the miscea system
from the power point. After 10 sec-
onds, reconnect the miscea system
to the power point. This should
reset the system and resolve any
minor system glitches.
Flush the faucet by letting the
water run for a few minutes.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
Switch the faucet off, and clean
the sensor ring in the sector with a
damp cloth.
If problem persists, please contact
miscea GmbH for further technical
support.
Check the mains water supply is
set to completely open.
Check the shut off valve (if avail-
able) is set to completely open.
If the problem persists, please
contact miscea GmbH for further
technical assistance.
Solution
You can adjust the amount of
dispensed liquid with the remote
control.
Contact miscea GmbH for further
technical assistance.
V 23.01
Advertenties
Hoofdstukken
Inhoudsopgave
