ENGLISH
3. UNPACKING
Children should not be allowed in reach of the packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of danger.
Do not lift or manoeuvre the carton by using the shipping bands.
When moving the unit by hand, observe local/national regulations and hold the unit from its
base during lifting.
Always wear protective gloves when carrying the unit.
When handling the carton or the unpacked unit, work in pairs to prevent injury.
Remove shipping carton, tape(s) and packing. If packing material is left in the ice dispenser, it
will not work properly.
DIM-30DE-1
1) After removing the packaging, make sure that the ice dispenser is in good condition. If in doubt, please do not use the ice
dispenser and contact a professionally qualified person.
2) Remove the protective plastic film from the exterior. If the ice dispenser is exposed to the sun or to heat, remove the film after
the ice dispenser cools.
3) Remove the package containing the accessories. Check the contents according to "2. ACCESSORIES".
DIM-30DE-2
1) After removing the packaging, make sure that the ice dispenser is
in good condition. If in doubt, please do not use the ice dispenser
and contact a professionally qualified person.
2) Remove the protective plastic film from the exterior. If the ice
dispenser is exposed to the sun or to heat, remove the film after
the ice dispenser cools.
3) Remove the package containing the accessories. Check the
contents according to "2. ACCESSORIES".
4) Unscrew and lift off the front panel.
5) Remove the shipping tape holding the bin control switch inside.
4. LOCATION
This ice dispenser is not intended for outdoor use.
The ice dispenser should not be located next to ovens, grills or other high heat producing
equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
To avoid a hazard due to instability of the appliance, the location should provide a firm and
level foundation for the ice dispenser.
WARNING
CAUTION
NOTICE
WARNING
4
Bin Control
Switch
Front Panel
Screw