Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
* Water supply pressure should be minimum 0.07 MPa (0.7 bar) and maximum 0.78 MPa (7.8 bar). If the pressure exceeds 0.78
MPa (7.8 bar), use a proper pressure reducing valve. Do NOT throttle back the supply tap.
* A plumbing permit and services of a licensed plumber may be required in some areas.
* The ice dispenser drain is gravity fed, so ensure the drain hose has an adequate pitch or fall.
* Drain lines should not be installed directly to the sewer system. A vertical air gap of a minimum of 5
cm should be between the end of the drain hoses from the ice dispenser and the floor drain.
* Be sure to use the new hose-sets supplied with the appliance. Do not reuse any old hose-sets.
DIM-30DE-1
1) By means of a suitable spanner or wrench, tighten the 1/2-3/4 nipple (accessory) into the Rc1/2 fitting on the rear of the ice
dispenser as indicated. P.T.F.E. tape and/or a suitable sealing compound should be used to obtain a leak free joint.
Note: Jointing compounds should be approved and suitable for potable water use.
2) Attach the angled end of flexible inlet hose (accessory) to free end of 1/2-3/4 nipple ensuring rubber sealing washer is
correctly positioned. Hand tighten sufficiently to provide leak free joint.
3) Attach the other end of inlet hose to the water supply tap, noting that the washer is correctly positioned before hand tightening
as above.
4) Attach the grey flexible outlet hose (accessory) to the R3/4 fitting as indicated, confirming fitment of rubber washer before
finally hand tightening the joint. The hose can be cut to length as necessary to suit position of main drain.
DIM-30DE-2
1) Attach the angled end of flexible inlet hose (accessory) to the R3/4 fitting on the rear of the ice dispenser as indicated,
ensuring rubber sealing washer is correctly positioned. Hand tighten sufficiently to provide leak free joint.
2) Attach the other end of inlet hose to the water supply tap, noting that the washer is correctly positioned before hand tightening
as above.
3) Attach the grey flexible outlet hose (accessory) to the R3/4 fitting as indicated, confirming fitment of rubber washer before
finally hand tightening the joint. The hose can be cut to length as necessary to suit position of main drain.
Inlet
Hose
Outlet
Hose
DIM-30DE-1
Water Supply
Inlet Rc1/2
1/2-3/4 Nipple
Inlet
Hose
Drain Outlet
R3/4
Outlet
Hose
Water Supply
Inlet R3/4
Drain Outlet
R3/4
DIM-30DE-2
7
ENGLISH
5cm air gap
Floor
Drain
Water
Supply Tap
Inlet Hose
Advertenties
Inhoudsopgave
