• For best results with the blower, main-
tain a distance of 5 - 10 cm from the
ground.
• Direct the flow of air away from you.
Be careful not to catch any heavy ob-
jects in the jet of air which could cause
injuries or damage.
• Start work with the highest blowing
power to quickly collect the leaves ly-
ing around. Select a lower blowing
power to compact the previously col-
lected pile of leaves.
• Before blowing, use a broom or rake to
loosen any leaves stuck to the ground.
• Hold the machine by the handle (5)
when working.
Transport
Information on transporting the machine:
• Switch off the device and remove the
battery. Make sure that all moving
parts have come to a complete stop.
• Carry the machine with two hands.
Use the handle (5) and the underside
of the blower pipe (1) for this.
Cleaning, maintenance
and storage
WARNING! Risk of injury due to un-
intentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the machine and remove the
battery (9). You should have any repair
and maintenance work that is not de-
scribed in these instructions carried out by
our Service Centre. Only use original re-
placement parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Maintenance
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
• Check the covers and protective
devices for damage and correct fit. Re-
place these if necessary.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• out of the reach of children
The storage temperature for the re-
chargeable battery and the device is
between 0 °C and 45 °C. Avoid extreme
cold or heat during storage to ensure the
battery output is not adversely affected.
Remove the rechargeable battery from the
device before storing the device (see the
separate operating instructions for the bat-
tery and charger).
• You can remove the blower pipe (1)
from the motor housing (3) for stor-
age (see Removing the blower pipe
(Fig. A), p. 13).
Wall mounting
You can hang the machine on the wall us-
ing the attachment (14).
Requirements
• Screw or nail (head diameter: 7 - 10
mm) (not included)
• Screwdriver or hammer (not included)
• Dowels, if necessary (not included)
GB
IE
NI
15