Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Troubleshooting
Error message
Mower outside
Mower lifted
Mower tilted
Mower overturned
Mower trapped
Loop signal lost
Motor fault
High temp
Battery abnormal
Wheel spinning faults where the mower will stop in a single spot and wheel(s) spin is a
combination of uneven and/or wet ground. The solution is to add soil to level the ground.
Ensure good drainage of the lawn before mowing, and not to mow during heavy rain and
water logging.
If the boundary wires are in the wrong connectors (so the signal is clockwise not count-
er-clockwise) then the mower will attempt to be outside the perimeter. If the mower leaves
the area constantly then change the wires around at the charging station (moving the
wire in red connector to black and vice versa).
Cause
Mower is outside
the perimeter
Mower is lifted away
from the ground.
Mower is tilted too much
Mower is upside down
Mower is trapped by
obstacles.
Power supply or the wire
is not connected to the
station or the cable has a
been broken.
Blade motor or drive
motor is stuck.
The motor current is too
high.
The battery temperature is
too high.
The battery is damaged.
- 25 -
User Manual
Solution
Place the mower inside
the perimeter.
Move the mower to a flat
part of the lawn.
Move the mower to a flat
part of the lawn.
Return the mower to its
normal position.
Remove the obstacles.
Check the connection of
the power supply,
chargingstation and
boundary wire. are okay.
If not repair with this.
Clear the grass or soil in
cutting area and driving
wheels. Cut the high
and thick grass with a
conventional lawn mower.
Wait until the temperature
decreases.
Contact
service@zoefrobot.nl
Advertenties
Inhoudsopgave
