Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Getting started:
Set the cutting height
The first cut of the season or long thick wet
grass will need the highest setting (5.5cm).
Gradually reduce to desired height once all
ground has been covered. This may take a
few days or a few weeks. If the perimeter
wire is pegged to the surface of the garden
rather than buried, it is a good idea to let
the wire "bed in" to the surface of the lawn,
during which time it is advisable to keep
the mower on an elevated blade setting.
NOTE during first few days of mowing the
grass may look stripy or patchy where the
mower has covered /not covered. This is
normal and will become even after several
days once the full lawn area has been
mowed.
First use
When starting for the rst time the
control panel will ask for setting a new
PIN code.
Please remember the PIN code you set.
Status
Standby
Mowing
Spiral Mow
Returning
Charging
Charge to work
Emergency stop
Error
Firmware update
Pressing the start button and closing the
flap will cause the mower to start a
perimeter circuit after which it will begin
randomly mowing the lawn.
The first few mows will appear random and
unfinished, this is normal. With the multiple
passes the mower makes over time, this
will even out, and by using zonning and
spiral spot mowing a desirable e ect can
be achieved in less time. These methods
are explained on page 19.
New season mowing
Between mowing seasons when the mower
is not operating (during winter months)
the grass can become unkempt and
thickets emerge. On new season setup
review mowing pass and address any
problem areas.
Meaning
Mower is ready to work
Mower is mowing automatically
Mower is mowing spirally
Mower is going back to station
Mower is charging
Mower is charging and will continue program when charged
Mower is stopped manually
Mower cannot work
Firmware is updating
- 15 -
User Manual
Advertenties
Inhoudsopgave
