Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
The main display shows the active power in watts, and the sub-display shows
the apparent power in "VA".
Use the button "F1 Display" to change the measured values: voltage "V" and
current "A", power factor "PF" and frequency "Hz".
Once you are done with the measurement, switch off the load and unplug it.
Unplug the measuring adapter from the socket and switch off the multimeter.
11.13.2 Follow these steps to measure DC power:
Note
– The DC adaptor is an optional item.
– You can purchase it on
Optional adaptor shown below:
PRECONDITIONS:
The multimeter is switched OFF.
D
The DC power supply is switched OFF.
D
The test load is switched OFF (if applicable).
D
1. Connect the DC adaptor plugs to the corresponding multimeter sockets:
DC adaptor: [10A, COM, V/Ω 250V] → multimeter: [10A, COM, °CHzVΩ].
2. Connect the DC power supply to the DC adaptor using suitable cables (e.g.,
4mm male to male banana plugs).
– DC power supply "OUTPUT" (+) connect to power adaptor red "INPUT" port
(+).
– DC power supply "OUTPUT" (-) connect to power adaptor black "INPUT"
port (-).
3. Connect the test load to the DC adaptor "OUTPUT" ports.
www.conrad.com
under item no.: 2890767
85
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
