Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INSTALLATION
Safety
INSTALLATION
7.
Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1
General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
- Fit the appliance to a vertical wall that is heat-resistant to at
least 80 °C.
- Maintain the minimum clearances to adjacent objects.
- The specified voltage must match the mains voltage. Observe
the type plate.
- Never install the appliance directly below a wall socket.
- Only use a permanent connection to the power supply.
- Ensure the appliance can be separated from the power
supply by an isolator that disconnects all poles with at least
3 mm contact separation. Do not install the appliance with a
fixed power cable.
- When installing the heating appliance in rooms with a
bath and/or shower, observe the safety zone according to
VDE 0100, part 701, in accordance with the details on the ap-
pliance type plate.
The mains junction box must not be installed in safety zone 1
or 2 in this instance.
- Install the appliance in such a way that switching and control
equipment cannot be touched by a person in the bath or
shower.
- Design all materials in accordance with the rated consump-
tion of the appliances.
7.2
Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
7.3
EU conformity and Ecodesign Directive
As of 01/01/2018, the EU conformity of these appliances is addi-
tionally dependent on compliance with ecodesign requirements.
These appliances may only be installed and commissioned in con-
junction with external room temperature controllers that have the
following functions:
- Electronic room temperature control and day of week control
- Adaptive control of the start of heating
www.stiebel-eltron.com
The following STIEBEL ELTRON room temperature controllers meet
these requirements:
Designation
RTU-TC
SRC C digital
Failure to observe these requirements will result in the loss of
the CE designation.
8.
Appliance description
8.1
Appliance layout
4
3
1 Natural stone panel
2 Wall mounting brackets with fixing screws
3 Adjustable spacer stud
4 Power cable
A heating conductor, featuring 2 safety temperature limiters with
automatic reset, is laid in a duct system milled into the back of the
natural stone panels. The duct system is then filled with marble
adhesive which acts as a cover.
8.2
Standard delivery
The following are delivered with the appliance:
- 3 wall mounting brackets with fixing screws
- 1 adjustable spacer stud
- MHx 35-115 E: 1 reflector panel
- MHx 145-165 E: 2 reflector panels
Note
The hexagon screws and rawl plugs for wall mounting
are not included in the standard delivery.
8.3
Required accessories
Only use the appliance in conjunction with the STIEBEL ELTRON
room temperature controllers listed in chapter "EU conformity
and Ecodesign Directive".
MHJ E | MHS E | MHP E | MHG E |
Part no.
238912
234417
1
2
15
Advertenties
Hoofdstukken
Inhoudsopgave
