Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Hang the party-tent heater on the hanging eye with the karabiner hook so that the party-tent
heater is 40 cm from the ceiling.
Check that the karabiner hook is correctly closed.
2. Hanging on a frame (e.g. a tent frame)
Make sure that the party-tent heater can hang freely from the attachment point you have
selected and that it is sufficiently sturdy to bear the weight of the heater. Secure it properly so
that it cannot sag, slide or move in any other way.
Seek a location in the frame that fulfils all of the requirements;
Use the additional security chain with a karabiner hook at each end to secure effectively:
- Hook the security chain to the ring on the hanging chain that is attached to the party-tent
heater, using the karabiner hook;
- Wind the security chain around the frame once or twice;
- Then attach the second karabiner hook also to the ring at the hanging chain; this will
ensure that the party-tent heater remains 40 cm from the frame.
Check that the karabiner hook is closed properly and that the party-tent heater is securely
attached. It should not slide, sag or move at all!
Take care! The control box must be positioned at least 40 cm from the tent canvas,
cover or any other item!
The following applies to both methods:
Run the electrical cable along the hanging chain and secure at
multiple points with a tie-wrap. The first tie-wrap must be
secured to the third link as the first few links become hot. Make
sure that the cable is tight along the chain but do not hang the
device on the cable! Run the electrical cable from the (hot) party-
tent heater to a socket.
Your party-tent heater is now ready for use.
OPERATING
Insert the plug into the socket. Check beforehand whether this
socket meets the requirements indicated on the party-tent heater's
specification plate, i.e. 220-240V / 50Hz.
By pushing the left switch to I (ON), the smaller, lower lamp will go
on and the corresponding indicator light will come on. The party-
tent heater will emit 600W of heat.
By pushing the right switch to I (ON), the again will switch on the
larger, higher lamp (900W). The corresponding indicator light will
come on. The party-tent heater will emit 900W of heat.
10
Advertenties
Inhoudsopgave
