2.4 Electronics
•
If the power fails during use, turn off the product immediately and unplug the product.
•
If the surface of the product is cracked, turn off the product to avoid electric shock.
•
Check both power cord and plug regularly for signs of damage or wear, and if there is
any, do not use the product and have the power cord and/or plug replaced or repaired
by authorized service personnel.
•
Do not immerse the product, power cord or plug in water. If water does get inside or
on the product, turn the product off immediately and contact our customer service
department.
•
Use and store the product so that the cables cannot be damaged.
•
To avoid electric shock, do not use the product if you suspect the power cord or plug
is damaged. A damaged power cord or plug should be repaired or replaced by a
professional (an authorized distributor).
•
Do not unplug the product by pulling the power cord. This may cause fire or electric
shock.
•
If black smoke comes out of the product, unplug the product immediately. Wait until the
smoke is gone before removing the contents of the product and contact our customer
service department.
•
Do not leave the cable(s) hanging over the edge of a table or countertop.
•
Do not place the cable(s) on hot surfaces or near oil.
•
Do not tuck the cable(s) under rugs or blankets. Never lay the cable(s) in a walkway.
•
Do not move the product by pulling the cord or twist the cord.
•
Before connecting the product, make sure that the mains voltage indicated on the rating
plate matches that of your mains supply.
•
Make sure that you do not trip over the cable(s) and that the cable(s) are not kinked,
twisted, or stuck.
•
The product is not suitable to be controlled by an external timer or a separate remote
control.
3. Instructions for use
ATTENTION!
◊ Use only the handle to move the product. Do not touch the hot parts.
◊ Use only cold tap water. Never use carbonated water.
◊ The water in the product is hot! Be careful when pouring.
3.1 Before first use
•
Clean the product before using it for the first time.
•
Fill the product to the max line with water, boil the water and throw it away again.
•
Repeat the above step two to three times before using the product.
20