Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
SINGLE TEMPERATURE CONTROLLER/SPLITTER (PDTC)
This temperature controller can be used with the following combinations:
•
Jacket and gloves with push button.
•
Trousers and gloves with push button.
•
Socks and gloves with push button.
These operations can only be performed after correctly connecting a Gerbing
battery connection cable (see battery connection cable manual) or a 12V-DC
plug.
1. Connect the long cable (red feature) directly to the battery cable or
12V-DC plug.
2. Connect the short cable (jacket, white characteristic) directly to the
connection plug (jacket) of the inner jacket.
3. Connect the blue cable directly to the connection plug (gloves, blue
characteristic) of the inner jacket.
4. If using the vehicle battery: put the vehicle on ignition or start the vehicle.
5. The lights on the push buttons of the gloves flash red, green, blue, orange,
then off successively. If you have the latest push button with internal
memory, the push button will remain blue on first use.
6. By pressing the controller button, you can set the temperature of the
jacket from positions 1 to 5, where 1 is the lowest position and 5 is the
highest position.
7. Pressing the button a little longer turns the regulator off.
8. By pressing the push button of a glove, you can set the desired temperature
of that glove (see glove manual).
NOTE! This regulator has an internal memory that remembers the last temperature
setting and activates it when the regulator is used again.
Setting 1:
20%
Setting 2:
40%
Setting 3:
60%
Setting 4:
80%
Setting 5:
100%
Optional: the PDTC can also be operated with a single remote control
(R-PDTC)
EN
Advertenties
Inhoudsopgave
