A defective appliance may cause electric
■
shock. Never switch on a defective
appliance. Unplug the appliance from the
mains or switch off the circuit breaker in the
fuse box. Contact the after-sales service.
Cracks or fractures in the glass ceramic
Risk of electric shock!
■
may cause electric shocks. Switch off the
circuit breaker in the fuse box. Contact the
after-sales service.
:
Warning – Risk of injury!
Saucepans may suddenly jump due to liquid
between the pan base and the hotplate.
Always keep the hotplate and saucepan bases
dry.
]Causes of damage
C aution!
C a u s e s o f d a m a g e
Rough pot and pan bases scratch the ceramic.
■
Avoid boiling pots dry. This may cause damage.
■
Never place hot pots or pans on the control panel,
■
the display area or the surround. This may cause
damage.
Damage can occur if hard or pointed objects fall on
■
the hob.
Aluminium foil and plastic containers melt on hot
■
hotplates. Oven protective foil is not suitable for your
hob.
Overview
You will find the most frequently caused damage in the
following table.
Damage
Cause
Stains
Boiled over food
Unsuitable clean-
ing agents
Scratches
Salt, sugar and
sand
Rough pot and
pan bases
scratch the
ceramic.
Discolouration
Unsuitable clean-
ing agents
Pan abrasion (e.g.
aluminium)
Blisters
Sugar, food with a
high sugar con-
tent
Measure
Remove boiled over food imme-
diately with a glass scraper.
Only use cleaning agents that
are suitable for glass ceramic.
Do not use the hob as a work
surface or storage space.
Check your cookware.
Only use cleaning agents that
are suitable for glass ceramic.
Lift pots and pans when moving
them.
Remove boiled over food imme-
diately with a glass scraper.
7Environmental protection
I n this section, you can find information about saving
E n v i r o n m e n t a l p r o t e c t i o n
energy and disposing of the appliance.
Energy-saving tips
Always place suitable lids on saucepans. When
■
cooking without a lid, considerably more energy is
required. A glass lid means that you can see inside
without having to lift the lid.
Use pots and pans with even bases. Uneven bases
■
increase energy consumption.
The diameter of pot and pan bases should be the
■
same size as the hotplate. In particular, small
saucepans on the hotplate cause energy losses.
Please note: cookware manufacturers often indicate
the upper diameter of the saucepan. This is usually
bigger than the diameter of the base of the pan.
Use a small saucepan for small quantities. A larger,
■
less full saucepan requires a lot of energy.
Cook with only a little water. This will save energy.
■
Vitamins and minerals in vegetables are preserved.
Always cover as large an area of the hotplate as
■
possible with your saucepan.
Switch to a lower heat setting in good time.
■
Select a suitable ongoing cooking setting. You will
■
waste energy by using an ongoing cooking setting
which is too high.
Use the residual heat of the hob. For longer cooking
■
times, you can switch the hotplate off 5-10 minutes
before the end of the cooking time.
Environmentally-friendly disposal
Dispose of packaging in an environmentally-friendly
manner.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning
used electrical and electronic appliances
(waste electrical and electronic equipment -
WEEE). The guideline determines the
framework for the return and recycling of used
appliances as applicable throughout the EU.
Causes of damage
en
25