Download Inhoudsopgave Inhoud Print deze pagina

Tips; Set-Up And Connection - Niceey DE30 Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Niceey AirFryer DE30
It is not possible to synchronise the
cooking zones subsequently while the
device is operating.
STAND BY MODE
When the POWER button (10) is pressed, the
control panel (1) is activated. If the device is not
operating and no button is pressed for 10 minutes,
the device switches to stand- by mode.

TIPS

Generally no oil or only a small amount of
oil ( 2 to 3 teaspoons) is required for
preparing food.
Very light pieces of food could be swirled
around by the circulating air. If necessary,
we recommend sticking them together
The cooking time is dependent on the size
and quantity of the food and on the
temperature. However, in general the
cooking time is shorter than in a conven-
tional oven. Start with a shorter cooking
time and gradually increase it if required .
Mix the food around from time to time or
turn it with plastic or wooden tongs to
obtain an even cooking result.
Check the condition of the food in between
times and, if it is cooked, switch o the
device, even if the programme has not yet
nished.
SET UP AND CONNECTION
PLEASE NOTE!
Check the device and the connecting
cable for damage each time before
putting it into operation. Use the device
only if it is undamaged and in working
order.
Never place the device on a soft surface.
The ventilation openings on the bottom
of the device must not be covered.
Ensure there is su cient clear space on all
sides. Do not place the device below
kitchen wallunits or similar cupboards.
The rising steam could cause damage to
them!
Only connect the device to a plug socket
that is properly installed and matches the
technical data of the device. The plug
soket must also be readily accessible after
connection so that the connection to the
mains can quickly be isolated.
Do not use any extension cables.
Do not connect the device along with
other consumers (with a high wattage) to
a multiple soket in order to prevent
overloading and a possible short circuit (
re).
Make sure that the connecting cable is
not squashed, bent or laid over sharp
edges and does not come into contact
with hot surfaces (e.g. of the device).
ENG
10

Advertenties

Hoofdstukken

Inhoudsopgave
loading

Inhoudsopgave