Advertenties
Beschikbare talen
Beschikbare talen
10- Installation
10.1 Preparation
▶ Take the appliance out of the packaging.
▶ Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.2.1
2x
2x
10-2.2
10-3.1
10-3.3
28
10.2 Noise reduction pads installation instructions
1. When opening the shrink package,you will find the
noise reduction pads. These are used for reducing
noise. (Fig. 10-2.1)
2. Lay the washing machine down to its side, porthole
pointing upwards, bottom side towards operator.
3. Take out the noise reduction pads and remove the
double-sided adhesive protective film; the noise redu-
ction pads under the washing machine cabinet as sho-
wn in Figure 10-2.2.(two longer pads in position 1and 3,
two shorter pads in position 2 and 4). Finally set the m-
achine upright again.
Warm tip:
Noise reduction pad is optional , could help to reduce
noise , please assemble it or not according to your
own demand.
10.3 Dismantle the transportation bolts
10-3.2
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1.
Remove all 4 bolts on the rear side and take out
plastic spacers (Fig. 10-3.1)(Fig. 10-3.2).
2.
Fill left holes with blanking plugs
10-3.4
(Fig. 10-3.3) (Fig. 10-3.4).
Note: Keep in safe place
Keep the transportation bolts in a safe place for later
reinstall the bolts.
EN
Advertenties
