Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Cleaning the Strainer
1. Switch off the sand filter and set the Control Valve to the
Closed function.
2. Close the connection valves.
3. Remove the Strainer Cover by
unscrewing it.
4. Take out the Strainer, remove any debris.
5. Put the Strainer back into position.
Ensure the hole in the strainer is aligned.
6. Ensure the Seal Ring is in place. Secure
the Strainer Cover back.
7. Open the connection valves.
NOTE: The Strainer must be emptied and
cleaned periodically. A dirty or blocked
strainer will reduce the performance of the
sand filter.
Lowering or Draining Pool Water
1. Switch off the sand filter and set Control Valve to the Drain
function.
2. Detach the Hose from the pool's Port A and sand filter Port
A and attach to Port D.
3. Switch on the sand filter and press the "RESET" button to
run the filter and remove the pool water.
WARNING: DO NOT DRY RUN THE SAND FILTER.
Winterization and long-term storage
In areas that have freezing winter temperatures, pool
equipment must be winterized to protect against damage.
Allowing water to freeze will damage the sand filter and void
warranty.
1. Backwash the sand filter.
2. Drain the pool according to the pool owner's manual.
3. Unscrew the drain valve cap at the bottom of the tank and
release the remaining water.
4. Disconnect the two Hoses from the pool and the sand filter.
16
Advertenties
Inhoudsopgave
