Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Installation inside the wall
cupboard
Note: The extractor hood housing inside
the wall cupboard can be boarded up (e.g.
with chipboard).
Please observe the following:
– The shelf must not be rest upon the
extractor hood housing.
– The board at the front should not be
attached to the housing.
– Ensure that access is possible for
replacing filters or by Customer Service.
Weight in kg:
Exhaust air
7,0
The manufacturer reserves the right to make design
alterations in the interests of technical development.
Electrical connection
WARNING: THIS APPLIANCE MUST BE
EARTHED
IMPORTANT: Fitting a Different Plug:
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow
Blue
Brown
If you fit your own plug, the colours of these
wires may not correspond with the identify-
ing marks on the plug terminals.
This is what you have to do:
1. Connect the green and yellow (Earth)
wire to the terminal in the plug marked
'E' or with the symbol (
coloured green or green and yellow.
2. Connect the blue (Neutral) wire to the
terminal in the plug marked 'N' or
coloured black.
3. Connect the brown (Live) wire to the
terminal marked 'L', or coloured red.
30
Re-circulating air
8,0
– Earth
– Neutral
– Live
), or
Electrical connection
The extractor hood may only be
connected to an earthed socket that has
been installed according to the relevant
regulations. If possible, site the earthed
socket directly above the wall cupboard or
in its immediate vicinity.
The earthed socket should be
connected via its own power circuit.
If the earthed socket is no longer
accessible following installation of the
extractor hood, ensure that there is a
permanently installed disconnector.
If it is necessary to wire the extractor
hood directly into the mains:
The extractor hood may only be connected
up by a qualified electrician approved by
the appropriate electricity company.
A separator must be installed in the
household circuit. A suitable separator is a
switch that has a contact gap of more than
3 mm and interrupts all poles. Such
devices include circuit breakers and
contactors.
Electrical specifications:
Are to be found on the name plate inside
the appliance after removal of the filter
frame.
Before undertaking any repairs,
always disconnect the extractor hood from
the electricity supply.
Length of the connecting cable: 1,30 m.
This extractor hood complies with EC
regulations relating to the suppression of
RF interference.
Advertenties
Inhoudsopgave
