Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
• Clean the soldering tip ❼ on the moist solder sponge ❻ .
soldering tip by melting solder ❷ onto it .
• The soldering tip must be tinned again after cleaning . Re-tin the hot
• Place the soldering tip on the soldering joint and heat it up .
• Position the solder (with flux) between the soldering joint and the soldering
tip so that it can melt .
• Keep the solder there until it melts and runs over the entire soldering joint .
• Immediately remove the soldering tip afterwards so that you do not
overheat the molten solder .
• Let the solder solidify and avoid vibrations .
NOTE
The flux is either included in the solder or it is applied separately . When you
make your purchase, you should check
the type of application it should be used for and which solder is suitable for
use .
Maintaining and cleaning
WARNING!
disconnect the power cord from the power
outlet, and wait for the machine to cool down
before you attempt to work on the machine .
• Clean the device after you finish your work .
• To clean the housing, use a cloth and a mild detergent (if necessary) .
• Never use sharp objects, petrol, solvents or cleaning agents that can
damage plastic .
• Do not allow liquids to get inside the device .
NOTE
Spare parts (e .g . soldering tips) can be ordered from our service hotline .
Disposal
28
|
GB
RISK
OF
INJURY!
Always
PLS 48 D2
Advertenties
Hoofdstukken
Inhoudsopgave
