Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Slider controller
Switch on the induction hob, press the optional key to select heating zone, the indicator next to the key will flash
for 5 seconds, during this period, during this period, it's power can be adjusted from level 2 to 8 by the slider
controller; Slide a scontroller from left to right, it is increase steps, slide from right to left to reduce steps.
!
Slider controller can adjust power level only,can't adjust timer function!
If the Display Flashes "
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centred on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minute if no suitable pan is placed on it.
When You Have Finished Cooking
1. Touch the heating zone selection control that you wish to switch off.
2. Turn the cooking zone off by scrolling down to"0" . Make sure the display shows"0" and then "H".
3. Turn the whole cooktop off by touching the ON/OFF control.
4. Beware of hot surfaces indicator "H" will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an energy saving function - if you
!
want to heat further pans, use the hotplate that is still hot.
Locking the Controls
• You can lock the controls to prevent unintended use (for example children accidentally turning the cooking zones on).
• When the controls are locked, all the controls except the ON/OFF control are disabled.
To lock the controls:
Touch the keylock control. The timer indicator will show "Lo".
To unlock the controls:
1. Make sure the induction hob is turned on.
2. Touch and hold the keylock control for a while.
3. You can now start using your induction hob.
When the hob is in lock mode, all controls are disabled, except the ON/OFF. You can always turn the induction hob off
with the ON/OFF control in an emergency, but you would have to unlock the hob first in the next operation.
Overheating Protection
The appliance is equipped with a temperature sensor which can monitor the temperature inside the induction hob.
When an excessive temperature is monitored, the Induction hob will stop operation automatically.
Detection of Small Articles
When an unsuitably sized or non-magnetic pan (e.g. aluminium), or some other small item (e.g. knife, fork, key) has
been left on the hob, the display flashes "
fan will keep cooling down the induction hob for a further 2 minutes.
Auto Shutdown Protection
Auto shutdown is a safety protection function for your induction hob. It will automatically turn off after a certain period of
time. The default working times for various power levels are shown in the below table:
Power level
Default working timer (hour)
When a pot is removed, the induction hob can stop heating immediately and automatically switch off after 1
minute.
!
People with a heart pacemaker should consult their doctor before using this unit.
Using the Timer
• You can set it to turn one cooking zone off after the set time is up.
• You can set the timer up to 99 minutes.
Setting the Timer to Turn off One Cooking Zone
1. Touch the heating zone selection control that you want to set the timer for.
2. Touch timer control, the minder indicator will start flashing and "30" will show in the timer display.
3. Set the time by touching the "+" and "-" buttons.
Hint: Touch the "-" or "+" control of the timer once - time will decrease or increase by 1 minute.
Touch and hold the "-" or "+" control of the timer - time will decrease or increase by 10 minutes.
4. Touch the "-" control to reduce the time outstanding to zero or press the "timer control" when the "00"
shows in the minute display to cancel the timer.
5. When the time is set, it will begin to count down immediately. The display will show the remaining time and the
timer indicator will flash for 5 seconds.
NOTE: The red dot next to power level indicator will illuminate, indicating that zone is selected.
NOTE: Slider switch cannot be used for the timer adjustment.
NOTE: Timer display will show the shortest set time of the selected zones, and that cooking zone with the
shortest set time will be with the red dot flashes.
6. When cooking timer expires, the corresponding cooking zone will switch off automatically.
!
Other cooking zones will keep operating if they have been turned on previously.
" Alternately with the Heat Setting
" and the hob will automatically go in the standby mode in 1 minute. The
1
2
3
8
8
8
4
5
6
7
8
4
4
4
2
2
4
9
2
6
or
0
H
6
30
00
36
6.
--
Advertenties
Inhoudsopgave
