Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
▲
BREAK-IN PROCEDURE
▲ CAUTION! Do not attach air chuck or other tools to the outlet until unit have been checked and
start procedure has been completed.
IMPORTANT: Do not operate compressor before reading instructions, otherwise damage
may result.
1. Turn regulator fully clockwise to open airflow.
2. Turn switch to OFF position and plug in power cord.
3. Turn switch to AUTO position and run unit for 30 minutes to run the pump parts.
4. Turn regulator knob fully counterclockwise. Compressor will build to maximum preset pressure
and shut off.
Figure 5:
▲
5. Turn regulator knob clockwise to bleed off air. Compressor will restart at a preset pressure
(about 6 bar).
6. Turn regulator knob counterclockwise to shut off the air and turn switch to off position.
7. Attach chuck or other tool to outside. Open the pressure switch to AUTO position, the
compressor starts work and pumps air into the tank. It shuts off automatically when unit
reaches its maximum preset pressure. In the OFF position, the pressure switch cannot function
and the compressor will not operate. Make sure switch is in OFF position when connecting or
disconnecting power cord to electrical receptacle.
MOISTURE IN COMPRESSED AIR.
Moisture in the air will change to water when air is compressed or temperature is drop. When
humidity is high or when a compressor is in continuous use for a long time, Water will collect in
the tank. If you use a paint spray or sandblast gun, Moisture will be carried from the tank
through the hose, and out of the gun as water mixed with the spray material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when spraying
other than water based paints. If sandblasting, it will cause the sand to case and clog the gun
rendering it ineffective. A dry filter in the air line, located nearby the gun as possible, will help
eliminate this moisture.
SAFETY VALVE
▲ WARNING! Do not remove or attempt to adjust the safety valve!
Safety valve should be checked under pressure occasionally by pulling the ring by hand. If air
leakage after ring has been released, or valve is stuck and cannot be actuated by ring, it MUST be
replaced.
REGULATOR (figure 6)
1. Regulator adjusts air pressure to fit an
air-operated tool or paint spray gun.
2. Adjust outlet air pressure by turn the
knob as Fig 6 show.
▲
▲
▲
Figuur 6:
f
e
or
f
et
Advertenties
Inhoudsopgave
