Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
▲ WARNING! Motors, electrical equipment and controls can cause electrical
arcs that will ignite a flammable gas or vapor, Never operate or repair in or
near a flammable gas or vapor, Never store flammable liquids or gases in the
vicinity of the compressor.
▲ CAUTION! Compressor parts may be hot even if the unit is stopped.
9. Keep fingers away from a running compressor, fast moving and hot parts will
cause injury and/or burns.
10. If the equipment should start to abnormally vibrate, STOP the engine/motor
and check immediately for the cause, vibration is generally a warning of trouble.
11. To reduce fire hazard, keep engine/motor exterior free of oil, solvent, or excessive
grease.
▲ WARNING! Never remove or attempt to adjust safety valve. Keep safety valve
free from paint and other accumulations.
▲ DANGER! Never attempt to repair or modify a tank! Welding, drilling or any
other modification will weaken the tank resulting in damage from rupture
or explosion. Always replace worn or damaged tanks.
▲ WARNING! Drain liquid from tank daily.
13. Tanks rust from moisture build-up, which weakens the tank. Make sure to drain tank
regularly and inspect periodically for unsafe conditions such as rust formation and corrosion.
14. Fast moving air will stir up dust and debris, which may be harmful. Release air slowly when
draining moisture or depressurizing the compressor system.
SPRAYING PRECAUTIONS
▲ WARNING!
Do not spray flammable materials in vicinity of open flame or near ignition sources
including the compressor unit.
15. Do not smoke when spraying paint, insecticides, or other flammable substances.
16. Use a face mask/respirator when spraying and spray in a well ventilated area to
prevent health and fire hazards.
17. Do not direct paint or spray other sprayed material at the compressor.
Locate compressor as far away from the spraying area as possible to minimize
overspray accumulation on the compressor.
18. To reduce fire hazard, Locate compressor far away wood cutter to avoid sawdust
be sucked into motor.
19. When spraying or cleaning with solvents or toxic chemicals, follow the instructions
provided by the chemical manufacturer.
ASSEMBLY
WHEEL AND RUBBER FEET ASSEMBLY
Before use, insert bolt and washer on tank to fasten the wheels and rubber feet supplied
in the carton, too keep machine on a horizontal line, See Figure 1.
▲
:
AIR FILTER ASSEMBLY
Remove transit plug and replace with air filter supplied in the carton, See Figure 2.
▲
Figure 2:
Advertenties
Inhoudsopgave
