Download Inhoudsopgave Inhoud Print deze pagina

Start-Up; Requirements For The Set-Up Location; Installation Under A Wall Cupboard; Dismantling - SilverCrest SKR 3W D6 Beknopte Handleiding

Dab+ keuken
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Connect the power adaptor to an electrical
 
outlet that is always easily reachable so that
in case of an emergency the plug can be
unplugged immediately .
Pull the power adaptor out of the power supply
 
to completely disconnect the product from the
mains network .
The power adaptor continues to draw a
 
small amount of electricity, even without the
radio being operated, as long as the power
adaptor is connected to the power supply . To
completely switch off the power adaptor, it
must be disconnected from the mains network .
Do not subject the product to physical shock or
 
strong vibrations .
If smoke or unusual sounds are observed,
 
immediately unplug the power adaptor from
the power supply .
The power adaptor shall not be covered .
 
Disconnect the power adaptor from the power
 
supply when the product is not in use and
before cleaning .
Let the product dry completely before
 
connecting it to the mains supply and before
storage . Allow the product to cool down
completely before storage .
NOTE: This product is equipped with rubber
feet to protect delicate surfaces . It cannot be
ruled out that furniture care agents will attack
or damage the rubber feet .
˜ Start‑up
˜ Requirements for the set‑up location
For the safe and trouble‑free operation of the product, the set‑up
location must fulfil the following requirements:
When setting up the product, place it on a firm, flat and
 
horizontal surface . Use the fold‑out foot
The surfaces of some items of furniture might contain
 
components that can soften the rubber feet of the product . If
necessary, place a mat under the product's rubber feet .
Set up or mount the product in such a way that the provided
 
ventilation openings and the loudspeaker
covered .
Do not operate the product in a hot, wet or extremely damp
 
environment or in the vicinity of flammable materials .
The mounting location must be selected so that the product
 
is not exposed to vapours . Do not install the product directly
over a hotplate .
˜ Installation under a wall cupboard
Using the supplied mounting plate
e .g . under a wall cupboard . Proceed as follows to mount the
product:
 
 
 
 
 
 
 
 
 
˜ Dismantling
.
14 ]
[
 
 
are not
[
16 ]
[
11 ]
Slide the mounting plate
to the rear and remove it from
11 ]
[
the product .
Find a suitable installation location for the product (see
"Requirements for the set‑up location") .
Hold the mounting plate
under the installation location .
11 ]
[
Ensure that the front edge of the mounting plate is approx .
3 .3 cm behind the front of the cupboard so that the product
is flush with the cupboard after installation . The side edges
of the mounting plate
must be spaced approx . 5 .8 cm
11 ]
[
away from adjacent cabinets or walls .
Mark the 4 mounting points with a pencil .
Using a pin or nail, make a small depression at the
respective marking points . In hardwoods, drill a hole with a
depth of approx . 5 mm in the markings using a Ø 2 .5 mm
wood drill bit . Be careful not to drill the hole all the way
through .
If required, place the supplied spacers
cupboard and the mounting plate . If you are using the
spacers
, you will need the long mounting screws
[
17 ]
Screw the mounting plate
tight using the mounting screws
[
11 ]
(
or
) .
18 ]
[
19 ]
[
With the top of the product against the mounting plate
push the product back until it clicks into place .
Check to ensure that the product is properly locked in place
and safely route the power cable and the wire aerial .
Pull the product forwards off the mounting plate
Unscrew the screws (
or
[
18 ]
19 ]
[
remove the mounting plate
[
11 ]
3 .3 cm
5 .8 cm
, you can install the product
between the
17 ]
[
.
18 ]
[
,
[
11 ]
.
11 ]
[
) on the mounting plate and
from the wall cupboard .
GB/IE/NI
9

Advertenties

Inhoudsopgave
loading

Deze handleiding is ook geschikt voor:

400111 2204

Inhoudsopgave