Inhoudsopgave
Advertenties
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND BEFORE
!
DISENGAGING BRAKE ARM. NEVER DISENGAGE THE BRAKE WHEN
THE MACHINE IS ON A SLOPE / GRADIENT. NEVER TOW THE MACHINE WITH THE
BRAKE ENGAGED AND POWER PLUG CONNECTED! REMOVE BATTERY FUSES
41
The TTV 678 is equipped with a free-wheel
function that will enable the operator to
move / tow the machine. The motor brake is
disengaged by opening the brake arm on the
side of the drive wheel (see Fig.41).
43
Once the key has been inserted (see Fig.43)
the motor brake will be fully disengaged.
The machine will now be in full free-wheel
mode.
45
Pull the power connector block apart and refit
the two retaining knobs.
When destination place reached, remove
brake disengage key, connect power plug, fit
fusses
WHEN THE BRAKE IS DISENGAGED AND POWER PLUG IS DISCONNECTED THE MACHINE IS IN
FREE-WHEEL MODE AND HAS NO BRAKE FACILITY, WHEN TOWING THE MACHINE
!
Remember to remove the brake disengage key when you reach your final destination / before using the machine.
NOT FOLLOWING DESCRIBED METHOD COULD DAMAGE MAIN CONTROL UNIT AND VOID THE WARRANTY
48
www.numatic.co.uk
Free-wheel Function & Towing
WARNING!
ENSURE THAT A SUITABLE TOW BAR IS USED.
42
Your start-up kit includes a brake drive
disengage key (329945, see Fig.42) which
can be inserted between the brake arm and
drive housing
(see Fig.43).
44
A
Undo and remove the two retaining knobs
(fig.A&B).
46
When towing the machine ensure that a
suitable tow bar is used.
Care must be taken when towing; WHEN
TOWING DO NOT EXCEED AVERAGE
SPEED OF 3 KPH. The machine can be
towed from the front bar as indicated (see
Fig.46).
!
B
!
Advertenties
Inhoudsopgave
