ULTIMATE SPEED ULGD 10 A1 Vertaling Van De Originele Bedieningshandleiding pagina 17
Verberg thumbnails
Zie ook voor ULGD 10 A1:
- Vertaling van de originele bedieningshandleiding (101 pagina's) ,
- Vertaling van de originele bedieningshandleiding (57 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
Before use / Using the device
battery exhibits the same tempera-
ture as the environment.
z Using the device
z Connection
Note:
Always observe the instructions
from the vehicle manufacturer or
the battery manufacturer.
Charging using the battery clamps:
Disconnect the minus pole
„
connection cable (black) of the
vehicle from the minus pole of the
battery first before charging and
maintenance charging if the bat-
tery is continually connected in
the vehicle. The negative pole of
your battery is usually connected
to the car body of the vehicle.
Then disconnect the plus pole
„
connection cable (red) of the
vehicle from the plus pole of the
battery.
Connect the output cable with the
„
plug
o the connecting cable
15
with clamps
18
Only then connect the "+" pole
„
quick-contact connection terminal
(red)
of the vehicle battery
19
charger
to the "+" pole of the
1
battery.
Connect the "–" pole quick-con-
„
tact connection terminal (black)
to the "–" pole of the battery.
21
16
GB/IE/NI
.
Connect the mains cable
„
vehicle battery charger
socket.
Charging using loops:
The connecting cable with
„
loops
must be permanently
17
connected to the battery.
Disconnect the battery from the
„
vehicle. Loosen the nut on the
battery's positive terminal (red).
Now insert the red loop
the nut connected to the battery's
positive terminal, and then
retighten the nut. Make sure that
the loop
does not slip when
13
tightening the nut.
Repeat with the black loop
„
the battery's negative terminal.
Afterwards, reconnect the battery
„
to the vehicle.
Plug the cover cap of the connect-
„
ing cable with loops
contacts of the connecting cable
with loops
. When the charger
17
is not being used, this must
always be carried out, in order to
prevent a short circuit.
Remove the cover cap
„
connecting cable with loops
before you start charging.
Connect the output cable with the
„
plug
with the connecting cable
15
with loops
.
17
Connect the mains cable
„
vehicle battery charger
socket.
of the
12
to the
1
under
13
on
14
over the
16
of the
16
,
17
of the
12
to the
1
Advertenties
