Troubleshooting - Parkside PSHL 2 D1 Bedienings- En Veiligheidsinstructies
Automatische lashelm
Verberg thumbnails
Zie ook voor PSHL 2 D1:
- Bedienings- en veiligheidsinstructies (57 pagina's) ,
- Bedienings- en veiligheidsinstructies (125 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
dark working conditions. The LED light switch
the end of work and when storing the welding helmet.
Battery replacement
If the battery charge level is too low you can replace the batteries. A low battery charge level is
indicated with a red warning light on the battery display
In order to open the battery compartment
„
upwards using the handle (see Fig. F).
You can replace the battery, once you have removed the cover of the battery compartment
„
F
Then, close the battery compartment
„
lid of the battery compartment
place.
NOTE: The batteries are used for the first darkening of the filter at the start of the welding procedu-
re. After that the power supply for the filter is supplied by the integrated solar cell.
z Troubleshooting
Faults
The filter does not become
dark steadily or flickers.
The reaction is slowed down.
Visibility is poor.
The welding helmet slips.
should always be switched of (left position "OFF") at
14
, you must push the lid of the battery compartment
15
15
. In order to close the battery compartment, you must put the
15
on and then push the handle downwards until the cover clicks into
15
Cause
1
The viewing pane
defective.
The arc sensor
17
is not clear.
The welding current is too low.
The ambient temperature is too low/high.
The sensitivity is too low.
1
The viewing pane
/rear lens
dirty.
The protective film on the rear lens
has not been removed.
The ambient light is not sufficient.
The wrong darkening level has been set.
The welding helmet slips.
.
13
Solution
is dirty or
Clean the viewing pane or replace it.
Clean the surface of the arc sensor
Set the sensitivity to the max. level.
Only use the welding helmet at tempera-
tures between -5°C and +55°C.
Adjust the sensitivity to a higher level.
4
is
Clean the viewing pane
rear lens
4
Remove the protective film.
Stellen Sie mehr Licht an Ihrer Arbeitsum-
gebung ein.
Provide more light for the working en-
vironment.
Re-set the darkening level.
15
.
15
1
/
4
.
GB/IE/NI
17
.
13
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
