Using The Device - Parkside PSHL 2 D1 Bedienings- En Veiligheidsinstructies
Automatische lashelm
Verberg thumbnails
Zie ook voor PSHL 2 D1:
- Bedienings- en veiligheidsinstructies (57 pagina's) ,
- Bedienings- en veiligheidsinstructies (125 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
z Using the device
NOTE: Only use the welding helmet with the rear lens
NOTE: Keep the arc sensors
After opening the package, immediately check to ensure that the package contents are complete and
are in perfect condition. Contact your dealer immediately if the package contents is incomplete or has
any defects. Do not use the device if it is defective.
Table to adjust the darkening levels
1,5
6
10
Grind
SMAW
MAG
TIG /
8
GTAW
MIG
(heavy)
MIG
(light)
PAC
PAW
4
5
SMAW:
Welding with coated electrodes
MIG (heavy):
MIG welding of heavy metals
MIG (light):
MIG welding of light metals and alloys
TIG/GTAW:
Inert gas welding
MAG:
Welding with metal active gas
PAC:
Plasma cutting
PAW:
Plasma welding
Grind:
Grinding function: Auto-darkening is not active. Only use the setting if you do not
use welding helmet for welding.
Before using the welding helmet each time, you must check that the protective screen as well as the
helmet is intact. If the protective screen should show signs of scratches, cracks or unevenness, then it is
essential that it is replaced before use, as otherwise this could lead to serious injuries.
Remove the protective film from the inside and outside of the visor.
„
Adjust the welding helmet with the help of the headband
„
headband
in order to adapt the welding helmet to the respective head size and the lateral control
6
dials on the headband
helmet is positioned as low as possible on the head and as close as possible to your face.
Before carrying out welding work, set the appropriate darkening level. The darkening level can be
„
set manually between 5 and 9 and between 9 and 13, by turning the darkening control
outside of the helmet. Using the darkening switch
of the UV filter
17
15
30
40
60
70
Grinding function – auto-darkening is not active
8
9
8
9
9
10
9
6
7
8
to lock the welding helmet. During the set-up, make sure the welding
7
fitted.
4
clean.
8
Arc current (Amps)
100 125 150 175 200 225 250 300 350 400 450 500
10
11
9
10
11
10
11
10
11
11
10 11
12
9
10
11
. Turn the rear control dial on the
5
you can set whether the darkening will be set
20
12
13
12
12
13
12
13
12
13
14
13
12
9
GB/IE/NI
600
14
13
14
14
on the
11
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
