Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Lift the panel up and pull it out (fig. C).
4.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left.
Troubleshooting
Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service as you may be able to
remedy the fault yourself.
Fault table
If a dish does not turn out as well as you had hoped, please
refer to the section Tested for you in our cooking studio. It
contains useful tips and information on cooking, baking,
roasting and frying.
:
Risk of electric shock!
Incorrect repairs are dangerous. Repairs must only be carried
out by technicians that have been trained by our after-sales
service.
Fault
Possible cause Remedy/information
The oven is not
Faulty fuse.
working.
Power cut.
The clock dis-
Power cut.
play is flashing.
The oven is not
Dust on the
heating up.
contacts.
The gas burner
Power cut or
will not ignite.
damp spark
plugs.
22
Look in the household fuse
box and check that the fuse
is in working order.
Check whether the kitchen
light or other kitchen appli-
ances are working.
Reset the time.
Turn the hotplate lever to
the right and left a couple of
times.
Light the gas burner with a
gas lighter or a match.
Insert the panel at an angle towards the back (fig. A).
1.
Insert the top panel at an angle towards the back into the
2.
brackets. The smooth surface must face outwards. (fig. B).
Put the cover back in place and press on it.
3.
Attach the oven door.
4.
Do not use the oven again until the panels have been
correctly installed.
Fault
Possible cause Remedy/information
The LED light-
The LED light-
ing on the glass
ing button has
cover is not
not been
working.
pressed.
The glass cover
on the appli-
ance is not fully
open or is
closed.
The glass cover
has not been fit-
ted correctly.
Error messages
When the display panel shows an error message with
the
button. The message will disappear. The set time
0
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
Error message Possible cause Solution/advice
A button has
"‹‚‚
been pressed
for too long or
has got stuck.
:
Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical
Assistance Service.
Press the LED lighting but-
ton.
Open the glass cover on
the appliance fully.
Make sure that the hinges
on the glass cover have
been fitted correctly; see
the "Glass cover" section.
, press
"
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
Advertenties
Hoofdstukken
Inhoudsopgave
