Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Lifting
• Make sure that the working load limit (WLL) and the jaw opening of the clamp (as indicated on the clamp) agree
with the load to be hoisted.
• Mount the lifting clamp onto the hoisting mechanism, either:
- safety shackle directly to a crane hook,
- coupling link or D-shackle,
- sling or chain, if necessary in conjunction with a U bolt or D-shackle.
• Ensure that all attachments have been tested and are of the correct tonnage. Make sure that coupling links and
shackles are of sufficient dimensions to allow the clamp to move freely in the hook
• Make sure the clamp has no visible signs of damage
• Check the lifting eye and chain for clearly visible signs of wear and/or damage
• Check the draw spring. It should demonstrate clear spring action when the safety lever is in the closed position
• Check the frame and jaw for signs of damage, cracks, and deformation (these may indicate overloading)
• Using the lever, make sure the clamp opens and closes smoothly (if the clamp's operation is difficult, the clamp
must be removed from service and inspected)
• Make sure the plate is free from grease and dirt in the place where the lifting clamp will be fastened
• Use the lever to open the clamp
• Position the jaw completely over the plate. Make sure that the clamp is positioned so as to balance the load when
it is being lifted
• Ensure that the lifting eye is facing towards the centre of the beam or structure
E
• Close the clamp by turning the lever back fully
• Lift carefully so that the lifting equipment has a proper grip. Make sure the clamp is not slipping
• If the load is slipping, follow the instructions in this chapter on lifting again
• If load continues to slip, see the next chapter, Chapter 6 – Maintenance
• Make sure the load is stably positioned before removing the clamp
6. Maintenance
For optimal safety, carry out a complete inspection of the clamp at least once a month. Stop using the clamp if:
• It is split or deformed, especially around the jaw corners
• The lifting eye and chain are visibly deformed
• The draw spring is stretched or broken
• The spindles are visibly deformed
• The retaining pins are missing
• The side(s) of the body at the location of the spacer pins is/are pressed in
• The clamping jaws are damaged or dirty
If any of the above-mentioned faults are observed, refer to Chapter 7 and Chapter 8.
7. Disassembling/Assembling
In view of the complexity of the clamp, it should only be assembled or disassembled by pewag austria GmbH or by
an authorised mechanical repair and service centre. See also Section 8.
8. Overhaul
At least once (1x) a year, or if the clamp becomes damaged, the clamp should be inspected, tested and if
necessary, overhauled by pewag austria GmbH or a recognised mechanical repair centre.
9. Disposal
At the end of its working life, the VNMW safety lifting clamp can be treated as scrap iron, provided it is rendered unfit
for further use.
10
Advertenties
Hoofdstukken
Inhoudsopgave
