Advertenties
Beschikbare talen
Beschikbare talen
Make sure that the persons standing in the work area are not hit by
particles which fly around.
Keep the handles dry, clean and free of oil and grease.
During operation always hold the machine with both hands.
Caution! The tool still runs for a little while after the machine was
switched off.
For further safety instructions, please refer to the enclosure!
The EPG 400 WP is made in protection class II. For protection purposes
the machine can only be run with a GFCI. The machine is standard
equipped with a PRCD protective switch integrated in the cord .
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch
Before starting your work, check the proper function
First, check the correspondence between voltage and frequency against
the data mentioned on the identification plate.
Voltage differences of + 6 % to – 10 % are allowed.
Switching on and off
Short-Time Operation
Switching-on:
press on/off switch
Switching-off:
release on/off switch
Permanent Operation (only for working with telescopic rod)
Switching-on:
press the on/off switch and, keeping it pressed, engage
the lock button
Switching-off:
press the on/off switch and let it go off again
Attention!
!
In case of every stop of the machine or a power cut, the lock
button has to be released immediately by pressing the
on/off switch. Consequently, you can avoid an unintentional
restart of the machine (physical hazard).
The machine is equipped with an electronic switch. With this switch the
speed can be regulated according to the pressure on the button. Only use
Electrical Connection
the tool on and off.
by pressing the TEST button.
16
Advertenties
