Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
STARTING THE SYSTEM
RECEIVER
Connect your appliance to the electricity supply. Press butt on «B» located on the receiver at the bottom of the appliance
to start the radiator. Indicator light «A» is illuminated and you will hear 2 short «beep» sounds. Pressing button «B» again
will turn off your radiator and produce a long «beep» sound. Indicator light «A» goes out, and no communication with the
remote control is possible.
Receiver indicator light status
Operating mode
Standby
Confort
Anti-frost
Confort -1°C (*)
Confort -2°C (*)
Pairing mode
Sensor fault or
Measured temp. > 35°C
The RF receiver is fitted with an independent regulation system which saves status informati on (start/standby) and tem-
perature setpoints to its memory. Storage of the last received setpoint ensures the temperature is still regulated even if
the transmitter is turned off or its batteries exhausted. Also note that during a power outage to the radiators, pairing does
not need to be reiniti alized.
Important: If your receiver is turned off , your radiator will not receive any commands from the remote control.
Status of 2c signal
Triple fast flashing red
Status of 2b and 2c signal
«2b» et «2c» flashing green alernately
«2b» et «2c» flashing orange alternately
Eco
Slow flashing green
Double flashing green
Double slow flashing
Off
Steady green
Indicator status
Radiator paused
Off
Steady green
Flashing green
green
Flashing Orange
Flashing red
Surface temperature limitation is not activated
Surface temperature limitation is not activated
IWiFi communications with transmitter indicator
The receiver was sucessfully reset
WiFi communications error
Indicator status
Radiator Heating up
Steady red
Flashing red-green
Slow flashing red-
green
Double flashing
redgreen
Double slow flashing
red-green
Flashing orange
--
EN
6
Advertenties
Hoofdstukken
Inhoudsopgave
