Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
INTRODUCTION
This appliance is a sealed electrical or mixed radiator designed
to be installed on a wall. It complies with NF-EN 60335-1 and EN
60335-2-30 standards as well as European EMC Directi ve 2014/30/
EU and Low Voltage Directi ve 2014/35/EU (CE labeling on all ap-
pliances). It is class II with IP44 protecti on index, and also complies
with European ECO Design Directive. This appliance is supplied
with a 3-wire power cable.
This radiator is fitted with a 868.3 MHz radio-frequency receiver
(thermostat) which is designed to provide comfort and save ener-
gy. It is designed to be remote controlled by a transmitter (remote
control) with programmable digital display. This operati ng mode
using radio-frequency allows you to control several radiators, adjust
the ambient temperature directly or through the use of another
operati ng mode. It is possible to adjust the ambient temperature
via the sensor located in the transmitter or receiver.
By default, the temperature is adjusted by the sensor located in the
receiver.
INSTALLATION
LOCATION
See the assembly instructions for attaching the radiator to the
wall. It is important that the thermostat is never placed directly
on the ground as there is a risk of breakage.
The remote control must preferably be installed on an interior
wall, at approximately 1.5 m from the ground, protected from wa-
ter spray, direct sunlight or any other direct thermal interference
such as a lamp, television set, heati ng pipe, draft , etc.
ELECTRICAL CONNECTION
Electrical installati on must comply with local or
nati onal regulati ons. The radiator must be connected using the
original power cable att ached to the appliance. If the radiator
isinstalled in a bathroom or shower room, it must be protected
using a circuit breaker (RCD) with a nominal residual current
notexceeding 30 mA. The radiator must be connected by a
competent and qualifi ed electrician. Please refer to the cabling
diagram below.
PARTICULAR RECOMMENDATIONS
Electric radiators (BAYO ONLY):
During operation, you may notice that some higher and lower ele-
ments are warmer than the rest of the radiator.
o Higher elements are not completely filled to allow expansion of
the heat-carrying liquid during the heating phase.
o Lower elements receive liquid returning aft er transmitting its
heat load.
EN
5
Advertenties
Hoofdstukken
Inhoudsopgave
