Philips 9000 Series Handleiding pagina 22
Verberg thumbnails
Zie ook voor 9000 Series:
- Gebruiksaanwijzing (88 pagina's) ,
- Handleiding (14 pagina's) ,
- Gebruiksaanwijzing (154 pagina's)
Advertenties
Beschikbare talen
Beschikbare talen
22
English
Note: If you press the on/off button of the SmartClean system during
the cleaning program, the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall socket during the
cleaning program, the program aborts.
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the cleaning result.
If you clean the shaver in the SmartClean system once a week, the
SmartClean cartridge lasts approximately three months.
1
Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2).
2 Remove the cleaning cartridge from the SmartClean system and
pour out any remaining cleaning fluid (Fig. 43).
You can simply pour the cleaning fluid down the sink.
3 Throw away the empty cleaning cartridge.
4 Unpack the new cleaning cartridge and pull off the seal (Fig. 36).
5 Place the cleaning cartridge in the SmartClean system (Fig. 37).
6 Push the top part of the SmartClean system back down ('click')
(Fig. 38).
Cleaning the shaver under the tap
Clean the shaver after every shave for optimal performance.
Caution: Be careful with hot water. Always check if the water is not
too hot, to prevent burning your hands.
Never dry the shaving unit with a towel or tissue, as this may
damage the shaving heads.
1
Switch on the shaver.
2 Rinse the shaving unit under a warm tap (Fig. 23).
3 Switch off the shaver. Pull the shaving head holder off the bottom
part of the shaving unit (Fig. 44).
4 Rinse the hair chamber under the tap (Fig. 45).
5 Rinse the shaving head holder under a warm tap (Fig. 46).
Advertenties
