Cleaning And Maintenance; Cleaning The Shaver In The Smartclean System - Philips 9000 Series Handleiding
Verberg thumbnails
Zie ook voor 9000 Series:
- Gebruiksaanwijzing (154 pagina's) ,
- Handleiding (14 pagina's) ,
- Gebruiksaanwijzing (139 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
20
English
3 Press the length selector and then push it to the left or right to
select the desired hair length setting (Fig. 29).
4 Switch on the appliance.
5 Move the appliance upwards while you exert gentle pressure.
Make sure the front of the comb is in full contact with the skin
(Fig. 30).
6 Clean the attachment after use (see 'Cleaning and maintenance').
Using the beard styler attachment without comb
You can use the beard styler attachment without the comb to contour
your beard, moustache, sideburns or neckline to a length of 0.5mm.
1
Pull the comb off the beard styler attachment.
Note: Grab the comb in the center to pull it off the beard styler
attachment. Do not pull at the sides of the comb (Fig. 31).
2 Switch on the appliance.
3 Hold the beard styler attachment perpendicular to the skin and
move the appliance downwards while you exert gentle pressure
(Fig. 32).
4 Clean the attachment after use (see 'Cleaning and maintenance').
Cleaning and maintenance
The accessories supplied may vary for different products. The box
shows the accessories that have been supplied with your appliance.
Cleaning the shaver in the SmartClean system
SmartClean system Plus has two phases: the rinsing phase and the
drying phase (Fig. 33).
Preparing the SmartClean system for use
Caution: Do not tilt the SmartClean system to prevent leakage
(Fig. 34).
Note: Hold the SmartClean system while you prepare it for use.
Note: If you clean the shaver in the SmartClean system once a week,
the SmartClean cartridge lasts approximately three months.
Advertenties
Inhoudsopgave
