Download Inhoudsopgave Inhoud Print deze pagina

Remote Control; Using The Device - GreenTec Clean Air Solution CAS 800 Handleiding

Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Usage
Filter
Timer
Child Lock
Speed

Remote control

The product is equipped with a remote control. The remote control comes with a coin cell
type CR 2032 (3 V). If you do not use the remote control for a long period, please take out
the battery.
Note: Before the first use, you need to open the battery compartment on the back of the
remote control and take out the plastic cover on the coin cell.

Using the device

Press the power button in order to start the device. The icon turns green and the device
runs in auto mode.
POWER
After switching on the device, press the mode button in order to switch between the
following 3 modes:
AUTO mode: the 'AUTO' icon appears.
TURBO mode: the 'SMOKE' icon appears.
MODE
SLEEP mode: the 'SLEEP' icon appears.
Press the mode button a maximum of 3 times in order to enable auto mode. In this mode,
the motor speed will be adjusted automatically to the degree of air pollution and the
ionizer (anion release) function will be activated.
Note: If you change the wind speed during auto mode, the auto mode will be disabled.
Speed level 1: PM2.5 = 0 - 35 | blue light
AUTO
Speed level 2: PM2.5 = 36 - 75 | green light
Speed level 3: PM2.5 = 76 - 150 | yellow light
Speed level 4: PM2.5 = 151 - 200 | red light
Press the mode button a maximum of 3 times in order to enable turbo smoke purification
mode. The device will switch to highest speed level.
TURBO
SMOKE PURIFICATION
Press the mode button a maximum of 3 times in order to enable sleep mode. Lights will
be reduced by half and the device will switch to the lowest speed level.
If the timer was set before activating sleep mode, the machine continues working in sleep
SLEEP
mode until the timer runs out and then goes into standby.
When pressing the child lock button for 5 seconds, child lock will be activated. While
active, the child lock disables all buttons and the device keeps running as set previously.
CHILD LOCK
Press the child lock button for 5 seconds to exit this mode.
8
Power
Display panel
Mode
Control panel
Manual CAS 800
EN

Advertenties

Inhoudsopgave
loading

Inhoudsopgave