Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Usage
Reassembly
Positioning of the device
This device must be placed on a dry, stable and flat surface.
Position the device in such a way that it is not touching any walls. Leave a minimum of 20 cm of free space around
the device and a minimum of 30 cm free space above the device. Otherwise, it could lead to damage or dirt on
the wall or device.
The rear of the device must face the wall; the front must face into the room. The front of the device can be
identified by the large-scale greentec logo print.
Operation/control panel
Commissioning
Check the outside of the device for damage prior to every use. If you notice damage, do not switch on the device
and contact the responsible retailer or manufacturer.
Once the device has been set up as described in the previous chapter, you may switch it on.
7
On each side, install the HEPA-13 & activated carbon compound filter.
Note: Please ensure the tab side (the side with the strip) is facing you.
On each side, install the pre-filter.
Note: Please ensure the tab side is facing you and that the two straps on
the bottom on the filters fit into the slots on the device.
Carefully install the two side plates as shown on the left.
Manual CAS 800
EN
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
