Jung FMSTD8UP Bedieningshandleiding pagina 7
Verberg thumbnails
Zie ook voor FMSTD8UP:
- Bedieningsvoorschrift (15 pagina's) ,
- Bedieningshandleiding (13 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
eNet
eNet radiografische stuureenheid DALI 1-voudig mini
Operating mode
Local Operation
Manual switch-off of the run-
on time
Switch-on brightness
Switch-on delay
82580923
J0082580923
Normal operation
Continuous on
Continuous off
Basic setting: Normal Operati-
on
On, Off
Basic setting: On
On, Off
Basic setting: Off
1...100 %
Basic setting: 100 %
0 s ... 24 h
Basic setting: 0 s
7/12
Normal operation
The output can be operated
with radio transmitters and the
Prog button.
Continuous on
The output switches to conti-
nuously "On". All operations of
radio transmitters and the
Prog button are ignored.
Continuous off
The output switches to conti-
nuously "Off". All operations of
radio transmitters and the
Prog button are ignored.
Blocks the output for operation
using the Prog button.
Allows manual switch-off of a
running run-on time. If the
parameter is switched off, then
a switch-off command will also
switch the actuator on. This
parameter is directly connec-
ted to the "Run-on time" para-
meter.
During brief operation, the out-
put switches on at the set
switch-on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum
brightness, then the system
will switch to the appropriate
limit value.
The load switches on after a
delay. Repeated switch-on
commands restart the delay
time. If the load has not yet
been switched on due to the
delay when a switch-off com-
mand comes, then the load
will remain off.
Note: The set time apply to
operation using radio transmit-
ters. The device is switched
immediately when the Prog
button is pressed.
28.06.2016
Advertenties
Inhoudsopgave
