Advertenties
Beschikbare talen
Beschikbare talen
Overwriting the master
Switch off the radio socket power supply for 10 seconds; then switch it back
on.
▻ The radio socket goes into programming mode for 3 minutes.
To ensure that the new master transmitter is programmed in
the desired radio socket only, all other receivers which are
connected to the same power supply must be deactivated
from the programming mode.
To do so, after switching the power back on, execute a drive
or stop command using the transmitter for the given receiv-
ers.
Now press the programming button of the new master transmitter for 10
seconds.
▻ The LED on the radio socket flashes briefly twice to confirm.
► The new master transmitter has now been programmed and the old mas-
ter transmitter overwritten.
The Centronic multi-channel transmitters have a central command (all LEDs
light up). If all the channels of the transmitter are selected, it is possible to op-
erate all of the assigned receivers/groups simultaneously. The central com-
mand must be programmed separately in the remote-controlled socket so that
it can be executed.
Central command
21 - en
Advertenties
Hoofdstukken
