6/ USING YOUR WINE CABINET FOR THE FIRST TIME
1. Connection and starting up
Wait 48 hours before plugging in your wine cabinet.
To switch it on, press and hold down button
Have your plug checked (presence of fuses, amps and 30 mA
circuit breaker). Fuse of 10A for one unit, 15A for two and 25A
for three.
Use of multi-socket plugs is not recommended if it does not respect
above electrical data as well.
Do not plug several cabinet into a multi-socket.
1I-A. Description (1-temperature model 5059V - 5259V)
A
B
C
P
A
Lighting mode
B
Door open alarm
C
Temperature zone
D
Fault sensor alarm
E
Temperature alarm
F
Carbon filter alarm
G
Validation and settings access button
H
Selection and adjustment buttons
II-B. Temperature settings
Press the
key for 5 s to activate.
1
Press the
key about 5 s.
The display starts to flash.
2
Press the
or
14
3
Press the
button to validate.
GB
for 5 seconds.
D
E
F
O
N
M
L
5 sec.
keys to set the desired temperature.
Check your type of wine cabinet
Press the
and
G
H
I
K
J
I
Lighting mode validation and access button
J
Carbon filter counter log access button
K
Power button
L
Threshold humidity alarm
M
Relative humidity level display
N
Hot circuit indicator light
O
Cold circuit indicator light
P
Temperatures display
The value on the display is the actual temperature inside the
cabinet, it is therefore necessary to wait before your new setting
takes effect.
The default setting is 12 °C/54 °F (ideal maturing temperature).
•
However, this setting can be adjusted between 5 and 22 °C (41° and
72°F).
Recommended maturing setting range: 10 to 14 °C (50° to 57 °F).
•
WARNING: to operate correctly your cabinet should be located in a
room with a temperature between 0° and 30 °C (32° and 95 °F).
keys simultaneously.
The touch keys are very sensitive. There
is no need to push the keys very hard. A
simple, gentle touch is enough to
register the setting. Think to lift your
finger from the control panel between
each touch.