eNet
Draadloze dimactor enkelvoudig DIN-rail
Hotel function
Operating hours
Information window
In the Information window, the load can be controlled and the information about the device can
be displays.
Display value
Current dimming value
Load state
Restraint
Switching cycle counter
Total operating hours
Operating hours
Display dimming principle
6.3 Hulp bij problemen
Aangesloten HV-LED- of compacte TL-lampen schakelen in de laagste dimstand uit of
flikkeren
De ingestelde minimale helderheid is te laag.
Minimale helderheid verhogen.
Aangesloten HV-LED- of compacte TL-lampen flikkeren
Oorzaak 1: Lampen zijn niet dimbaar.
Gegevens van de fabrikant controleren.
Lampen door een ander type vervangen.
Oorzaak 2: dimprincipe en lampen passen niet optimaal bij elkaar.
Bedrijf in een ander dimprincipe controleren, daarvoor evt. de aangesloten last verlagen.
32581602
10499444
On, Off
Basic setting: Off
0...65535
Basic setting: Current value
Explanations
The load can be dimmed using the slider or a
brightness value entry.
The load can be switched on or off.
Display of forced position status.
Display of the switching cycles with the factor
10, e.g. the value 5 x 10 is displayed for 50
switching cycles.
Display of the operating hours since the start
of operation.
Display of the operating hours since the last
restart in the Settings window.
Display of the used dimming principle.
12.03.2014
If the hotel function is activa-
ted, the system will dim to 20
% brightness when a switch-
off command is made. Switch-
off is only possible with a for-
ced position command.
Note: If the minimum
brightness is set to greater
than 20 %, then the system
dims to the set minimum
brightness when the hotel
function is activated.
The time is counted during
which the load is physically
switched on.
This parameter can be reset to
"0", for example after exchan-
ging the load.
The Reset button is used to
reset the counter to "0". The
device must be programmed
to apply the change.
14/16