Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
2
Figure 5-1
Mark the places for screws on the wall according to the
unit mounting holes or dimensions specified in Figure 5-
12. The drain pipe for condensate water must be smooth
enough to allow unobstructed water discharge.
As shown in Figure 5-2, fasten four screws (①) into a
proper masonry structure.
Figure 5-2 Diagram for fixing the unit body
Structure the square rod on the beam to
set the lifting bolts.
Directly set and use an angle steel for support.
2
1
1
Casing
assembly
1
1
1
1
Wood structure
Steel framework
Suspension bolt
Suspension bolt
gle steel
for support
Figure 5-4 Installation of lifting bolts
The footings shown in Figure 5-3 are optional. You can
purchase them separately and install them as follows:
1. Put the footings beside the unit to be installed.
2. Place the mounting holes on the unit base into the
corresponding footing locating pin and install screws
①*2 and ②*2 to fix the footing according to Figure 5-3.
1
Base
3) Install the unit following the steps below in case it
is ceiling mounted.
To match the existing structure, set the screw pitch
according to the unit dimensions.
Original concrete slab structure
Use embedded bolts, and pull bolts.
Newly set concrete slab structure
Set using embedded appliances, and embedded
type of bolts.
An
Knife-type
insertion piece
15
2
1
Base
Footing
Figure 5-3
Sliding-type
Reninforced bar
insertion piece
Embedded bolt(hanging and
embedded bolt of piping)
2
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
